Wrapping a 3-bar Slide (LV7/LV10/LV11)
Common to all shoulder belts, this is the most popular wrap that end users of the belts will need to know how to do. It is used when a piece of webbing is wrapped around a bar, or a bolt-in or snap-on end fitting kit is used with a 3-bar slide.
Instructions:
- Slide the webbing through slot 1 and 2 as shown.
- make sure the protruding strap end is long enough to have sufficient webbing length available for the following wrapping procedure. A minimum of 360 – 400 mm (14” – 16”) is recommended.
- the 3-bar slide shall be positioned as close as possible to either the roll cage bar or to the end bracket.
- wrap the free strap end from underneath around the roll cage bar or through the webbing slot of an end bracket.
- in case of the combination of a 50 mm bracket slot and 75 mm webbing, fold the webbing in as shown.
- wrap webbing back through slot 2 and 1.
- fold strap end back and run it through slot 2 again.
- make sure the strap end protrudes at least 100 mm (4“) or even longer from slot 2. If it is less than 100 mm disassemble and start over again. If longer, roll in the strap end and fix it by a cable tie to the shoulder belt.
- Check again for proper shoulder belt tilt lock adjuster positioning and for the 3-bar slide to be as close as possible to the roll cage bar or end bracket.
