« Back

Wrapping a 3-bar Bolt-In Bracket (B63/B40)

This wrap is used on all Formula Lap Belt Brackets, NASCAR Lap Belt Brackets, and any time you use a bracket that incorporates the 3-bar slide.

Instructions

  1. webbing shall wrap from the body facing side of bracket up into slot 1.
  2. pull through approx. 270 mm (11”) through and fold down through slot 3 temporarily leaving 50 mm (2”) of slack.
  3. fold back up from the body side through slot 1 and back down through slot 2.
  4. fold back through slot 3 and finally through slot 1
  5. pull at belt to check that wrap will further tighten.
  6. make sure the protruding strap end is at least 50 mm (2”) long. The webbing must be wrapped tightly!

« Back