Flexi-belt/Light-weight Wrapping System (LV4 with B14/B24)
This wrap is perhaps the most difficult wrap to carry out, but offers use of the lightest weight hardware, the least microslip, and most compact design of any other method. It is used on all Schroth Flexi-Belt Laps which are found on Profi II harnesses, as well as used with the Bolt-In sub strap brackets available for dual sub straps.
Instructions
- Place LV 4 with its thicker bar onto the bracket/latch.
- Run strap end through slot at LV 4 and then from underneath through webbing slot at bracket. Pull through at least 200 mm (8”) of webbing. Fold strap end over the wider bar of LV 4 and back through the gap between bracket bar and LV 4 bar.
- Slide strap end further through the webbing slot at bracket/latch and then fold the strap end through the slot at LV 4.
- Pull at the load taking strap and the bracket to make sure, the webbing is properly clamped by the wrap hardware.
- If this is not achieved, check for proper strap routing and follow these instructions step by step again.
- If the protruding webbing is significant longer than the minimum of 50 mm [2”], you may fold it over again, run it through webbing slot of the bracket/latch and again back and through the webbing slot at LV 4.
- In this case, the strap end now protrudes from the down side of the LV 4. The webbing must be wrapped tightly!
